3.2.6.2 CRU SENSOR PWB Board Removel
1. Remove the rear cover. @fertoS ection31L 1.1.)
2. Remove thetopcover. (Refer to Section 3.2.l.2.)
3. Remove theleftcover. @eferto Section 3.2.13.)
4. Remove the right cover. (Refer to Section 3.2.l.4.)
Remove the ELECcover. (R&r to Section 3.2.2.l.)
5.
6. Remove the fusing unit. (Refer to Section 3Q5.1.)
7. Disconnect connector P/Jl18 from the CRU sensor.
8.
2
9. Remove 2CBBscrews(M3 x8) securing the CRU sensor board, and remove it.
Figure 3-47. Removing the CRU SENSOR PWB Board
3.2.6.3 Erase Lamp Removal
1. Remove therear cover. (Refer to Section 3.2.l.l.)
2. Remove the fusing unit. (Refer to Section 32S.1.)
3. Remove 3 CBB screws (M3 x 8) securing the erase lamp, and remove it.
4 . Disconrl ect the connector from the erase lamp.
Figure 3-48. Removing the Erase Lamp
-
Rev. A
I