Cycle Settings - Frigidaire FASE7073NA Use & Care Manual

Cycle Settings

For best results
Follow the fabric care label instructions
on items to be dried.
Appropriate drying Temperature, Dryness Level and
Options will automatically be displayed for each cycle.
The settings can be changed before the cycle is started.
NOTE
To change settings after the cycle starts, press pause,
adjust the setting and press START to resume the cycle.
Drying Temperature
To change the preset temperature, press the temp
button to scroll to the desired setting.
To protect your fabrics, not all temperatures are available
with every cycle.
The temperature selected for the cycle will be remembered
and recalled each time that cycle is selected in the future.
sanitize
Recommended for durable fabrics and towels. Use this
selection to remove harmful bacteria from your clothing
or other items where sanitization is desired.
NOTE
Only sanitizing cycles have been designed to meet the
requirements of NSF P154 protocol for sanitization
effi cacy.
Sanitization Performance of
Residential Clothes Dryers
This option will kill 99.9% of bacteria with no carryover
of bacteria between loads. A higher temperature is
required. Please check fabric care labels to prevent
damage.
To return to factory
settings, press these
two buttons at the
same time and
hold until the signal
sounds.
NSF Protocol P154
OPERATING INSTRUCTIONS
high
Recommended for most cotton fabrics.
normal
Recommended for wrinkle free, easy care, lightweight
fabrics and bulky loads.
low
Recommended for delicate fabrics.
air dry
This setting (no heat) should only be used with a
Timed Dry cycle to dry items containing feathers,
down, foam rubber, plastics or rubber-like materials;
to refresh clothing, stuffed animal, pillows or blankets;
and to dust draperies.
Dryness Level (Auto Dry)
To change the preset level, press the dry level button to
scroll to the degree of dryness desired.
To protect your fabrics, not all dryness levels are available
with every cycle. If a dry level is not appropriate for the
cycle, it cannot be selected.
The dry level selected for the cycle will be remembered
and recalled each time that cycle is selected in the future.
Select the normal dry level for most Auto Dry cycles.
Occasionally a load may seem too damp or over-dried at
the end of the cycle. To increase drying time for similar
loads in the future, select more. For loads requiring less
drying time, select less.
Select damp for items you wish to partially dry before
hanging or ironing.
11