Move Dishwasher Close To Cabinet Opening - Whirlpool WDT710PAYB Installation Instructions Manual

Connect the " compression fitting to the water supply line prior
to installing the unit into the cabinet opening. Attach such that the
" connection is facing upward as shown above.
Copper tubing only: Put the tubing into the 90° elbow fitting as far
as it will go (the copper tubing bends and kinks easily). Slide the
nut and ferrule forward and start the nut onto the elbow threads.
Flexible braided connection: Secure nut to elbow using
ended wrench or adjustable wrench.
NOTE: Do not use Teflon ®† tape with compression fittings.
Move Dishwasher Close to Cabinet
Opening
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
NOTE: Do not install kick plate until instructed to do so
IMPORTANT: Double-check correct placement of utilities. Grasp
the sides of the dishwasher at the edges of the door panel. Move
dishwasher close to cabinet opening.
NOTE: Do not push on the front of the panel or on the console.
Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations
shown to prohibit them from moving when dishwasher is moved
into the cabinet opening.
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
16
Check that water line is on the left side of opening and drain hose
is near the center of the cabinet opening.
" open
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes or
falls open under its own weight, the door tension will need to be
adjusted.
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.