Whirlpool ACM 802/NE Instructions For Use Manual page 14

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.
For built-in dimensions and installation instruction, see the pictures in page 2.
• The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.
• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
• If an undertop oven is installed, make sure the oven is equipped with a cooling system.
• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them.
• In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.
• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance.
For the electrical connection, use an H05RR-F cable as specified in the table below.
230 V ~ +
230-240 V ~ +
230 V 3 ~ +
400 V 3N ~ +
400 V 2N ~ +
A B
- Based on the wiring diagram (see figure) either keep or remove the metal jumpers between the screws on the terminal block L1-L2 and N1-N2.
- If the cable is provided, see the connection instructions attached to the cable.
- Make sure all six screws on the terminal block are tightened after connecting the cables.
Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2 and between N1-N2).
2
3 x 4 mm
2
3 X 4 mm (Australia only)
2
4 x 1.5 mm
2
5 x 1.5 mm
2
4 x 1.5 mm
C
400 V 3N ~
400 V 2N ~ 230 V 3 ~ (Belgium only)
GB14
min. 20 mm
min. 5 mm
230-240 V ~ (Australia only)
230 V ~
230 V ~ (UK only)
400 V 2N ~ (Holland only)