To Turn Auto Sensitivity Back On - Eagle FISHEASY 320C Installation And Operation Instructions Manual

To adjust sensitivity in manual mode:
1. First, turn off Auto Sensitivity: from the Sonar Page, press
to
A S
UTO ENSITIVITY
2. Press ↑ to
Press ↓ or ↑ to pick a different sensitivity setting. When it's set at the
desired level, press

To turn Auto Sensitivity back on:

From the Sonar Page, press
NOTE:
To return to the original factory setting for Auto Sensitivity, see the
entry in this section on Reset Options. If sensitivity is in manual
mode, the Reset Options command will switch back to Auto and re-
set the factory setting at the same time.
Tip:
For quicker sensitivity adjustments, try leaving the Sensitivity
Control Bar on the screen as the chart scrolls. You can see the
changes on the screen as you press the up or down arrows. This is
handy when there's a lot of clutter in the water, and you are
matching the sensitivity to rapidly changing water conditions.
The Sensitivity Control Bar.
| .
ENT
|
S ENT
ENSITIVITY
.
EXIT
and the Sensitivity Control Bar appears.
|↓ to
MENU A
UTO
79
|
S ENT
ENSITIVITY
|↓
MENU
| .
EXIT