Connecting To A Network - Sony Alpha NEX-5R Instruction Manual

Notes
• Some images may not be displayed on the Smartphone, depending on the
recording format.
• The camera shares the connection information for [View on Smartphone] with a
device that has permission to connect. If you want to change the device that is
permitted to connect to the camera, reset the connection information by following
these steps. MENU t [Setup] t [Reset View on Smartphone]. After resetting
the connection information, you must register the Smartphone again.
• "PlayMemories Mobile" is not available in some countries/regions. [View on
Smartphone] is not available in some countries/regions that are not compatible
with "PlayMemories Mobile."

Connecting to a network

You can transfer images on the camera via Wi-Fi network and view them on
other devices. The setting procedure differs depending on your LAN router or
wireless LAN access point.
• A computer or TV that is already connected to a network is required at your
home, etc.
• Be sure to set the network connection inside your wireless LAN access point
area (the accessible area).
Refer to the table below for how to register the access point.
Access point
Your access point has the WPS button.
Other than above.
x WPS Push
1
Select MENU t [Setup] t
[WPS Push].
2
Press the WPS button on the access point you want to
register.
The camera starts communicating with the access point.
How to register
Use [WPS Push].
Use [Access Point Settings].
GB
GB
47