Appendix; Attaching The Stand (For Lc-80Le844U) - Sharp Aquos LC-60LE745U Operation Manual

Appendix

Attaching the Stand (for LC-80LE844U)

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a wall mount bracket to mount it.
Before attaching the stand to the TV, build a work
table on which to rest the TV.
• To build the table, use the cushioning materials used in the
packaging.
TOP-L
F R O
• Of the cushioning materials used, TOP-C is also used
during stand unit assembly. Be sure to assemble the stand
unit before building the work table.
■ Stand Unit Assembly
1 Confi rm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
2
1 Set the post for the stand unit onto the TOP-C.
2 Attach the base to the post.
3 Insert and tighten the 8 screws into the 8 holes
on the bottom of the base.
• Hold the stand unit securely with one hand, and then
tighten the screws.
2
1
■ Building the Work Table
3
Insert each of the cushioning materials in the
respective directions shown in the fi gure.
• Insert TOP-L and TOP-R into the left and right sides of
the case respectively.
• Insert TOP-C to fi t between the lines on the other side
of the case.
TOP-L
TOP-R
TOP-C
N T
3
Long
screws
1
FRONT
TOP-R
CASE
LINE
TOP-C
4
The case is equipped with push-in tabs to hold
the cushioning materials in place. Push in the
tabs (2 for each location) to secure the cushioning
materials in the case.
Push-in tabs
5
After you have built the work table, spread a
blanket or similar soft cloth over the table and then
lay the TV display down on the covered table.
• Do not use a small table for this.
■ Attaching the Stand to the TV
6 Insert the stand into the openings on the bottom of
the TV.
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
7 Insert and tighten the 4 screws into the 4 holes on
the rear of the TV.
Short
screws
• In the installation procedure, be careful not to catch your
fi ngers between the TV set and the fl oor.
79