Download Print this page
Samsung RF323TEDBSR Quick Manual

Samsung RF323TEDBSR Quick Manual

31.6 cu. ft. french door refrigerator (stainless steel)
Hide thumbs Also See for RF323TEDBSR:

Advertisement

Before calling service
If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)
1. Automatic Ice Maker does not work
• Allow your refrigerator to operate and
12
cool down for 24 hours (1 full day) be-
9
fore the ice maker starts producing ice.
6
• To fi ll the ice bucket to maximum ca-
pacity, dispense a few cubes 8 and 16
hours after installation.
• If ICE OFF is lit, the ice maker will not make ice.
• To activate the ice maker, press the ICE OFF
but-ton on the control panel so it is no lon-
ger lit.
2. Slow Ice cube freezing
• Check if the ice bucket is completely
inserted.
• Freezer temp may not be enough;
set it to -2°F or lower.
3. Small or bubbled ice cubes or Slow
water dispensing
• If the water fi lter is clogged, small or bubbled ice
cubes may be produced.
• Replace the water fi lter cartridge with a new one.
4. Water fi lter replacement
• Slowly turn the water fi lter 90°
clockwise so it is aligned with the
printing mark on the cover, lock-
ing the fi lter in position.
Make sure to align the water fi lter
label mark with center of cover fi l-
ter printing as illustrated.
• If you are in trouble of inserting the
water fi lter as high pressure of water, shut off the
water supply valve. For details, refer to the "Chan-
gig the water fi lter" section of the User Manual.
After installation or when replacing the
water fi lter, dispense at least a gallon
PUSH
PUSH
(2~3minutes) of water to remove trapped
air from the water line. Otherwise, water
may drip after dispensing water.
5. Water is not cool enough
• The fi rst glass of water may not be cold enough
because the stored water in the water valve has
not cooled completely. Dispense several glasses
of water and then it would be cool.
6. Water dispenser dripping
• If the water line is not inserted into the coupler
properly, air could penetrate into the water line
3
causing water dripping from the water dispenser.
• CAUTION : Insert the water line into the coupler com-
pletely and slide in the clip at the end of the coupler.
Red Clip
Red Clip
(1/4")
(1/4")
Cabinet
Cabinet
Tube
Tube
Dispenser
Dispenser
Door Tube
Door Tube
1. The Water Line must be fully Inserted to the center
Li
t b f ll I
t d
of transparent coupler to prevent water leakage
from the dispenser.
2. Insert the clip in the install pack and check that it
holds the line fi rmly.
Center of transparent coupler
Center of transparent coupler
clip A (1/4")
clip A (1/4")
(6.35mm)
(6.35mm)
7. Refrigerator or freezer Compartments
are warm
• Allow your refrigerator to operate and cool down for
24 hours (1 full day) to reach to the set temperature.
• Also, when you put room temperature or warmer
food into your refrigerator, it may need an additional
24 hours for the fridge to reach the set temperature.
8. Moisture forms on outside/inside of
refrigerator
• Wipe off the condensation with a dry towel (This
may occur during hot and humid seasons.)
• If the condensation occurs on the doors, turn off
the Energy Saving function.
• If you open the doors frequently or for too long, it
may cause moisture inside the fridge.
9. Noise Clicks, Pops, Cracks, Snaps
• These noises may be heard occasionally inside
the refrigerator. This is normal. This sound occurs
when various items contract or expand while
temperatures are changing; especially during
defrosting. This may also occur when electronic
devices including the ice maker are operating.
10. Display
<RF323TE**>
• Recommended Temp Settings : 0°F for freezer and
37°F for refrigerator.
• Filter indicator : The fi lter Indicator will be Red If you
use water about 300 qallons (6 month) Reset the indi-
cator (it will be Blue) after replacing the fi lter by holding
the "Alarm/Hold 3 sec for Filter Reset" button for
3 seconds.
• Ice off : Press the "Ice Off" button to turn the ice
making function off.
• Cooling Off (Show Room) mode : If the Display shows
the "0F 0F" code, it means that the Cooling Off func-
tion is activated and the refrigerator is not cooling. To
cancel the Cooling Off mode, hold the Energy Saver
+ Freezer buttons together for 5 seconds.
11. Cool Select Pantry (on some models)
• You can select your Pantry
temperature from among the
following.
Wine Party Dishes (38°F[3°C])
Fresh (38°F[3°C])
Chilled (34°F[1°C])
Deli (41°F[5°C])
12. Food stored in refrigerator is frozen
• If food with too much moisture is stored near the
cooling vents, it may get frozen. Be sure to keep
moist food away from the cooling vents.
13. Moving and Installing
• When installing, servicing or cleaning behind the
refrigerator, be sure of the following:
• To protect your fl oor's fi nish when moving the
refrigerator, cut a large section of the cardboard
carton and place under the refrigerator where
you are working.
• Pull the unit straight out and push back in straight
after fi nishing.
14. Leveling & Door Alignment
• Insert a fl at-blade screwdriver into a slot on the
control lever, turn it clockwise or counter-clock-
wise to level the door.
Control Lever
Control Lever
Flat-blade screw driver(-)
Flat-blade screw driver(-)
• Open the freezer drawer to gain an access to the
adjustable hinge pin. Next, adjust the refrigerator
door using the provided 0.16 inch wrench.
RAISE
RAISE
• If you need to add more height to the door, insert
the provided snap rings.
• For details, refer to the user manual "Adjusting the
level"
DA99-04022A REV(0.1)
ENGLISH

Advertisement

loading

This manual is also suitable for:

Rf323tedbbcRf323tedbww