Table of Contents
Advertisement
Using Smart Station
2. Right click on the network device of the Smart Station monitor (displayed as LAN9512/
LAN9514 USB 2.0 to Ethernet 10/100 Adapter), and select Enable.
NOTE
This process must be done before IP configuration.
3. Enter the static IP address assigned to the network device of the Smart Station monitor.
NOTE
To enter the static IP address, go to Control Panel
Sharing Center
Change adapter settings.
monitor (displayed as LAN9512/LAN9514 USB 2.0 to Ethernet 10/100 Adapter).
on your mouse.
Select Properties.
Select Internet Protocol Version 4 (TCP/IPv4).
Select Properties.
Configure the static IP and DNS settings.
Network and Internet
Network and
Select the network device of the Smart Station
Right-click
4. After setting the IP, click OK. When the following message appears, click No.
NOTE
•
A static IP address is assigned to a single network device. The above message appears when the
same static IP address is assigned to both the LAN network device on your PC (disabled) and the
network device of the Smart Station monitor. Ensure the network device you are not using is set to
Disable.
•
To use the LAN network on your PC, change the settings accordingly:
Set the network device of the Smart Station monitor to Disable.
the PC.
Configure the IP.
5. Click the Close button.
Enable the network device on
34
- Quick Links:
- What Is Smart Station
Hide quick links:
Advertisement
Table of Contents
