Table of Contents
Advertisement
Storage and Cleaning
Clean using a soft, dry cloth.
Wiping the 3D Eyewear with a soft cloth that is covered in dust or dirt may scratch the
eyewear. Shake off any dust from the cloth before use.
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the
paint to peel off.
Do not dunk the 3D Eyewear in liquid such as water when cleaning.
Avoid storing the 3D Eyewear in hot or highly humid locations.
Replacing the batteries
When the power lamp does not light, replace the battery with new one by
following instructions.
1. Loosen the screw and
remove the cover using the
screwdriver (included with the
television).
NOTE:
Use the specified type of battery (coin-shaped lithium battery
CR2032).
Do not insert the battery with the polarity (plus
backwards.
Dispose of the old batteries as non-burnable garbage, or in line with
the garbage regulations in your local area.
2. Replace the batteries, and then
replace the cover.
Always tighten the screw to hold the
battery case cover in place.
and minus
)
9
Advertisement
Table of Contents
