Table of Contents
Advertisement
Connecting the Collar Assembly
Step 1. Slowly raise the projector toward the upper assembly.
Step 2. Align the lower mounting plate with the upper collar
assembly.
The mounting notch on the lower
mounting plate should line up with the
mounting notch in the inner collar
assembly.
Safety Screw Installation
Step 1. The M4 x 12mm safety screw (located directly beneath
the safety tab) must be tightened securely before
installation is
complete. If the M4 x 12mm safety screw
not properly
secured, there will be an increased risk of
attachment failure,
which could result in damage to the
projector or injury.
Page - 8 -
NP30UC
M
Safe y t C
able
and
C
lamp
M ou
nt
ing
Pl
t a
e
Project
or
Step 3. Once the lower mounting plate engages the upper collar
assembly, the collar will twist and an audible "click" will signify
that the unit is
Step 4. Attach the safety cable clamp after the collar
Safety Cable
Safety Tab
M4 x 12mm
Safety Screw
M5 Security
Wrench
The NP30UCM comes equipped with a pre-installed safety cable.
The safety cable is securely fastened to the upper assembly of the
is
NP30UCM. When the installation is complete, attach the safety
cable to the projector plate.
properly attached.
Make sure that the unit is securely
attached before releasing.
assembly and mounting plate have been
Safety Cable
and Clamp
Mounting
Notch
Completely
Inserted
combined.
Upper
Assembly
Mounting
Plate
Installation Manual
Advertisement
Table of Contents
