Height Adjustment; Disconnecting The Collar Assembly - NEC NP30UCM Installation Manual

Versatile projector mount
Table of Contents

Advertisement

Height Adjustment

Be sure to support the weight of the projector before adjusting the height. This is a recommended two-person
step.
Step 1. Loosen the two (2) M8 x 12mm security screws on the
extension neck with the supplied M5 Allen wrench.

Disconnecting the Collar Assembly

THE FOLLOWING STEPS MUST BE PERFORMED BY TWO PEOPLE.
Please refer to Page 5 for instructions (Safety Locking Tab Operation) on how to disengage the mounting plate
from the collar assembly.
Use two hands to support projector while it is
being disconnected.
Step 1. While an assistant holds the projector with two hands,
grasp the collar assembly and turn the collar clockwise.
This will separate the two units.
Page - 10 -
M5 Allen Wrench
M8 x 12mm
Security Screw
Step 2. Slide the adjustable suspension neck into the desired
position.
Step 3. Re-tighten the two (2) M8 x 12mm security screws.
Step 2. Once the collar assembly is separated, unclip the
safety cable clamp.
Step 3. Place the projector on a soft flat surface.
Do not release the projector until the M8
screws are completely tight. This is a
recommended two-person step.
Safety Cable Clamp
Installation Manual
M5 Security Wrench
M8 x 12mm
Security Screw

Advertisement

Table of Contents
loading

Table of Contents