LG DLE4870W Owner's Manual page 27

7.3 cu. ft. ultra large capacity dryer with sensor dry (electric)
Hide thumbs Also See for DLE4870W:
Table of Contents

Advertisement

Available languages

Available languages

Installation test (Duct check)
Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
• Your dryer features FLOW SENSE
that automatically detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces energy use.
notE
F
The dryer should be cool before starting this test. If the dryer
was warmed up during installation, run the AIR DRY cycle for a
few minutes to reduce the interior temperature.
To activate the installation test:
1. Remove the drying rack and literature, and then close the
door.
Do not load anything in the drum for this test, as in may affect
the accuracy of the results.
E
2. Press and hold the SIGNAL ON/OFF and TEMP. CONTROL
buttons and then press the POWER button.
This button sequence activates the installation test. The code
will display if the activation is successful.
3. Press START/PAUSE button.
The dryer will start the test, which will last about two minutes.
The heat will be turned on and the temperatures in the drum
will be measured.
TM
, an innovative sensing system
A
D
G
4. Check the display for results.
During the two minute test cycle, monitor the FLOW SENSE
LED on the control panel. If the LED is turned off, when the
cycle ends, the exhaust system is adequate. If the exhaust
system is severely restricted, the LED will be turned on. Other
problems may also be shown with error codes. Refer to the
next page for error code details and solutions.
E
The LED turned on indicates that the exhaust system is severely
restricted. Have the system checked immediately, as performance
will be poor.
B
5. End of cycle.
At the end of the test cycle,
C
will end and the dryer will shut off automatically after a short
delay.
InstallatIon InstrUCtIons
F
G
will display. The test cycle
27
TM
B
C
D

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents