Download Print this page

Advertisement

9
CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assembly, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 24 volt-60Hz electric
power. The included transformer changes
standard 120-volt AC house power to 24 volts.
Plug the transformer into a 120-volt outlet only.
Be sure the outlet is always live so it can not be
switched off by mistake.
• Replace the top cover.
• Replace the salt hole cover.

PROGRAMMING THE CONTROL

CONTROL SETTINGS REQUIRED upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORMER IS PLUGGED INTO THE
ELECTRICAL OUTLET, 12:00 PM (flashing), and
PRESENT TIME is displayed. Program the control
as instructed below.
If
- - - is flashing, use the UP
set the correct model code as follows: F30 for
GXSF30H. If you pass by the correct code number,
use the DOWN
button. Then press the MODE
button to accept the correct model.
• A "beep" sounds while pressing buttons for control
programming. One beep signals a change in the
control display. Repeated beeps mean the control
will not accept a change from the button you have
pressed, and you should select another button.
• To program the control, you will use the UP
DOWN
and MODE buttons.
• Use the MODE button to select the desired control
function.
Installation Instructions
PROGRAMMING THE CONTROL
button to
,
SET PRESENT TIME OF DAY
1. Press the MODE button until
PRESENT TIME appears in the
display.
2. Press UP
or DOWN
button to set. The UP button
advances the time; the DOWN
button moves the time in
reverse.
If the present time is between noon and midnight,
be sure PM shows in the display. If the present
time is between midnight and noon, be sure AM
shows in the display.
NOTE: Each press of an UP
changes the time by one minute. Holding the
button changes the time at a rapid rate.
3. When the present time is correct, press MODE to
accept.
SET WATER HARDNESS NUMBER
1. Press the MODE button until
HARDNESS appears in the
display.
2. Press UP
or DOWN
to set your water hardness number in the
display. DOWN decreases the hardness value.
UP increases the hardness value.
NOTE: Each press of a button changes the display
by 1, between 1 and 25. Above 25, the display
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.
10
or DOWN
button
button

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: