Epson LX-1170+II User Manual page 82

Wide- format 9- pin printer
Table of Contents

Advertisement

Software
When you select ESC/P, the printer operates in the EPSON ESC/P
mode. When you select IBM 2380 Plus (for LX-300+II)/IBM 2381
Plus (for LX-1170II), the printer emulates an IBM printer.
0 slash
The zero character has a slash ( ) when this feature is turned on.
It has no slash (0) when this feature is turned off. The slash allows
you to easily distinguish between the uppercase letter O and a
zero.
High speed draft
When you choose On, the printer prints up to 300 cps (characters
per second) at 10 cpi (characters per inch). When you choose Off,
the printer prints up to 225 cps at 10 cpi.
I/F (interface) mode
The printer comes with three kinds of interfaces; a parallel
interface, a serial interface and a USB interface.
If your printer is connected to only one computer, choose Parallel,
Serial, or USB for the interface mode, depending on the interface
you use. If your printer is connected to two computers, select
Auto (automatic) to allow the printer to automatically switch
between interfaces depending on which one is receiving data.
Auto I/F (interface) wait time
This setting takes effect only when "I/F (interface) mode" is set
to Auto. This setting determines how long the printer waits when
it no longer receives data from an interface before it checks
whether a print job is being sent through the other interface. You
can specify 10 seconds or 30 seconds for the auto interface wait
time.
82

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lx-300+iiLx-1170ii

Table of Contents