Electrical Connections - Electrolux EMS26254OX User Manual

CONNECTING THE APPLIANCE TO
THE POWER SUPPLY
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven
from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230-240 V/50 Hz alternating current via a
correctly installed earth socket.
• If the appliance is to be operated in a
non-European country, the supply
voltage, current type and frequency of
the appliance indicated on the rating
plate must correspond with the
specification of your power supply. The
rating plate can be found on the inside
face of the control panel.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string to the
power supply cord to facilitate connection to
point (A) when the appliance is being installed.
• When inserting the appliance into the high-
sided cupboard, DO NOT crush the power
supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.
(A)

ELECTRICAL CONNECTIONS

WARNING!
THIS APPLIANCE MUST BE
EARTHED
The manufacturer declines any
liability should this safety measure
not be observed.
• If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut
off and the appropriate plug fitted.
• Remove the fuse from the cut off plug. The
cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into the 13 A socket in another
part of your home.
Important!
The wires in the mains lead are coloured in
accordance with the following code:
GREEN AND YELLOW
BLUE
BROWN
If you fit your own plug, the colours of the wires
in the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
• Connect the green and yellow (earth) wire to
the terminal in the plug which is marked with
the letter "E" or the earth symbol (
coloured green and yellow.
• Connect the blue (neutral) wire to the terminal
in the plug which is marked with the letter "N"
or coloured black.
• Connect the brown (live) wire to the terminal in
the plug which is marked with the letter "L" or
coloured red.
GREEN & YELLOW
BLUE
ENGLISH
EARTH
NEUTRAL
LIVE
) or
13 AMP FUSE
BROWN
CORD CLAMP
33