Table of Contents
Advertisement
Setting Various Functions
Setting a Password
[Password settings]
HDMI
Digital PC
Disables the projector unless the correct
password is entered.
MENU > [System settings] > [Other settings] >
[Password settings]
MENU > [System settings] > [Other settings] >
[Password settings]
Off
The projector can be used even if no pass-
word is entered.
On
The projector cannot be used unless you
enter your password.
Press the OK button to accept your setting
and then press the MENU button or EXIT
button (WX6000 / SX6000).
• [Off] is the factory default.
• You cannot set [On] unless you have com-
pleted [Register password].
Once you set a password, the password
entry screen appears at power-on.
Enter a 4 digit password.
For the WUX5000 / WUX4000, the pass-
word can be entered using the [ ] / [ ] /
[ ] / [ ] buttons. For the WX6000 /
SX6000, the password can be entered
using a combination of the numerical but-
tons and the [ ] / [ ] / [ ] / [ ] buttons.
[ ] / [1], [ ] / [2], [ ] / [3], and [ ] / [4]
Component
have the same function.
Analog PC
If the password is valid, the projection
starts. If you enter a wrong password three
times, the power will be turned off.
• The power is also turned off if no password
128
is input for 3 minutes.
T o C ancel the P assw ord
Turn off the projector and unplug the power
plug.
Hold down the MENU button on the side control
and connect the power plug. Make sure to keep
holding down the MENU button until a beep
sounds. When the beep sounds, the password
is canceled. (The entered password is also
reset.)
To forcibly cancel the password from the remote
control, in standby state press the MENU button
3 times, then press the POWER button.
Advertisement
Table of Contents
