Table of Contents
Advertisement
5.1.5
Marvell RAID utility
The onboard Marvell SATA 6.0 Gb/s controller allows you to create a RAID 0 or RAID 1 array
using two SATA hard disk drives. Refer to Chapter 2 of your motherboard user manual for the
exact location of the Marvell SATA 6.0 Gb/s connector.
To enter the Marvell utility, press <Ctrl> + <M> during POST.
All exisiting data on the hard disk drives will be erased when creating or deleting a RAID
array. Ensure that you have back up all your data in your hard disk drives before making
any change to the drive status.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology
HBA 0: Marvell 0
Virtual Disks
├
Free Physical Disks
└
├ PD 0: ST3160812AS
└ PD 8: ST3160812AS
Help
Marvell RAID on chip controller.
ENTER: Operation
Create a RAID Array
Move the selection bar to HBA 0: Marvell 0 and press <Enter>.
1.
Select Configuration Wizard and press <Enter>.
2.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Configure->Select free disks
HBA 0: Marvell 0
Virtual Disks
├
Free Physical Disks
└
*
├ PD 0: ST3160812AS
└ PD 8: ST3160812AS
Help
Use space bar to select the free disks to be used in the array.
ENTER: Operation
3.
Press <Space> to select the hard drives to be included in the RAID array. An asterisk
(*) appears in front of the selected hard drive. After selecting all the drives needed for
the RAID array, press <Enter> to continue.
ASUS ESC1000 G2
Information
Vendor ID
Device ID
Revision ID
BIOS Version
Firmware Version:
PCIe Speed Rate :
Configure SATA as:
▶
F10: Exit/Save
ESC: Return
Port ID
PD ID
Type
Status
Size
Feature Support :
Current Speed
Model
Serial
FW Version
▶
SPACE: Select
F10: Exit/Save
:
1B4B
:
9130
:
B1
:
1.0.0.1028
2.2.0.1105
5.0Gbps
AHCI Mode
:
0
:
0
:
SATA PD
:
Unconfigured
:
152626MB
MCQ 3G 48Bits
:
3G
:
ST3160812AS
:
9LS0F4HL
:
3.AAE
ESC: Return
▶
▶
5-7
Advertisement
Table of Contents
