Removing The Display Latch - Dell Inspiron 2650 User Manual

Display Assembly and Display Latch: Dell Inspiron 2600 and 2650
1 pull tabs
2 inverter connector on
system board
3 bottom flex-cable
connector
10. Pull the top flex-cable connector down and away to remove it from the display panel
connector.
Replacing the 15-Inch Display Panel
1. Reconnect the top flex-cable connector to the display panel connector.
2. Reconnect the bottom flex-cable connector to the inverter connector on the system board.
3. Replace the tape that secures the display panel connector and the tape that secures the
middle of the display-feed flex cable to the display panel.
4. Place the bottom edge of the display panel in the bottom of the top cover and elevate the
top of the panel with your hand.
5. Lay the display panel in the top cover.
6. Reinstall the eight M2 x 3-mm screws that secure the display panel to the top cover.
7. Reinstall the M2.5 x 5-mm screw that secures the display-feed flex cable to the display
assembly.
Display Latch
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and
remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.

Removing the Display Latch

1. Remove the keyboard.
file:///F|/Service%20Manuals/Dell/Inspiron/2600-50/display.htm (12 of 14) [2/28/2004 6:52:43 AM]