Connecting To A Wlan - Dell D630 - LATITUDE ATG NOTEBOOK User Manual

NOTE:
Wait for a minimum of 5 minutes after disconnecting your broadband
modem before you continue with the network setup.
8 Insert a network cable into the network (RJ-45) connector on the
unpowered broadband modem.
9 Connect the other end of the network cable into the Internet network (RJ-
45) connector on the unpowered wireless router.
10 Ensure that no network or USB cables, other than the network cable
connecting the modem and the wireless router, are connected to the
broadband modem.
NOTE:
Restart your wireless equipment in the order described below to prevent a
potential connection failure.
11 Turn on only your broadband modem and wait for at least 2 minutes for
the broadband modem to stabilize. After 2 minutes, proceed to step 12.
12 Turn on your wireless router and wait for at least 2 minutes for the wireless
router to stabilize. After 2 minutes, proceed to the step 13.
13 Start your computer and wait until the boot process completes.
14 See the documentation that came with your wireless router to do the
following in order to set up the wireless router:
• Establish communication between your computer and your wireless
router.
• Configure your wireless router to communicate with your broadband
router.
• Find out your wireless router's broadcast name. The technical term for
the name of your router's broadcast name is Service Set Identifier
(SSID) or network name.
15 If necessary, configure your wireless network card to connect to the wireless
network (see "Connecting to a WLAN" on page 65).

Connecting to a WLAN

NOTE:
Before you connect to a WLAN, ensure that you have followed the
instructions in "Wireless Local Area Network" on page 63.
NOTE:
The following networking instructions do not apply to internal cards with
Bluetooth® wireless technology or cellular products.
Setting Up and Using Networks
65