1 battery connector
4 Remove the battery connector from the connector on the system board.
5 Being careful not to break the plastic, slightly raise the corner of the mylar
above the battery.
6 While holding the mylar, grasp the battery and pull out of the battery
compartment.
Memory
You can increase your computer memory by installing memory modules on the
system board. See "Specifications" on page 183 for information on the memory
supported by your computer. Install only memory modules that are intended for
your computer.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the
NOTICE:
If your computer has only one memory module, install the memory module
in the connector labeled "DIMMA."
1
2 coin-cell battery
Product Information Guide
Adding and Replacing Parts
3 mylar
.
2
3
157