Before Working Inside Your Computer - Dell D630 - LATITUDE ATG NOTEBOOK User Manual

The computer turns off after the operating system shutdown process
finishes.
2 Ensure that the computer and any attached devices are turned off. If your
computer and attached devices did not automatically turn off when you
shut down your operating system, press and hold the power button for 4
seconds.

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from
potential damage and to help ensure your own personal safety.
CAUTION:
safety instructions in the
CAUTION:
or contacts on a card. Hold a card by its edges or by its metal mounting bracket.
Hold a component such as a processor by its edges, not by its pins.
NOTICE:
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
NOTICE:
on the cable itself. Some cables have a connector with locking tabs; if you are
disconnecting this type of cable, press in on the locking tabs before you disconnect
the cable. As you pull connectors apart, keep them evenly aligned to avoid bending
any connector pins. Also, before you connect a cable, ensure that both connectors
are correctly oriented and aligned.
NOTICE:
begin working inside the computer.
1 Ensure that the work surface is flat and clean to prevent the computer
cover from being scratched.
2 Turn off your computer (see "Turning Off Your Computer" on page 149).
3 If the computer is connected to a docking device (docked), undock it. See
the documentation that came with your docking device for instructions.
NOTICE:
and then unplug it from the network wall connector.
4 Disconnect any telephone or network cables from the computer.
150
Adding and Replacing Parts
Before you begin any of the procedures in this section, follow the
Product Information Guide
Handle components and cards with care. Do not touch the components
Only a certified service technician should perform repairs on your
When you disconnect a cable, pull on its connector or on its pull-tab, not
To avoid damaging the computer, perform the following steps before you
To disconnect a network cable, first unplug the cable from your computer
.