Windows 2000 Setup And Configuration; Power Options; Changing The Default Power Options - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Windows 2000 Setup and Configuration

To install and operate HAFM on the HP notebook PC, Windows 2000 must be
installed. Windows 2000 is not factory installed on the HP notebook PC. To install
Windows 2000, use the HP System Recovery CDs that come with the PC. See the
README.TXT file on Disk 1 of these CDs for specific instructions on performing a
factory installation. Note that the PC comes with recovery CDs for both Windows NT
Workstation 4.0 (single CD) and Windows 2000 Professional (two CDs). Use the
System Recovery CD for Windows 2000 Professional (the dual CD set).
Because this process requires the use of a CD-ROM drive, replace the internal Zip
drive with an internal CD-ROM drive prior to performing the installation.

Power Options

The default power options selected during the Windows 2000 installation allow the
system to enter standby and hibernate modes after a period of inactivity. Change these
defaults to prevent the PC from ever entering either of these modes by selecting a
pre-defined power scheme that never allows the system to enter standby or hibernate
modes.

Changing the Default Power Options

To change the default power options, complete the following steps:
1. Choose Start > Settings > Control Panel. The Control Panel window displays.
2. Double-click Power Options. The Power Options Properties dialog box
displays, as shown in
HAFM server installation guide
Figure 4–1.
4
4–1