Deactivate Zone Sets; Configure The Default Zone - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Deactivate Zone Sets

To deactivate zone sets:
1. Select the fabric in the Fabric Tree area for which the zone set is to be
2. Choose Configure > Deactivate Zone Set (Advanced Zoning submenu).
3. Click Start to begin the process and messages display to indicate deactivation

Configure the Default Zone

To configure the default zone:
1. Select the fabric in the Fabric Tree area for which the default zone is to be
2. Choose the Configure > Configure Default Zone (Advanced Zoning
3. The Configure Default Zone dialog box displays the current state of the
A default zone consists of all devices that have not been configured as members of
a zone in a currently-active zone set. When no zone set is active, then all devices
are considered to be in the default zone. If a zone set is active, then all connected
devices that are not included in at least one of the zones in the active zone set are
included in the default zone.
Enabling the default zone allows any device in the default zone to see any other
device in the default zone. If the default zone is disabled and no zone set is active,
then devices connected to the product cannot communicate.
Note:
High Availability Fabric Manager User Guide
deactivated.
The Deactivate Zone Set dialog box displays. Use this dialog box to
deactivate the current active zone set.
status. When the Close button displays, you can close the dialog box.
configured.
submenu). The Configure Default Zone dialog box displays. Use this dialog
box to enable and disable the default zone.
default zone (enabled or disabled). Depending on the current state, press Start
to enable or disable the zone. Messages display to indicate process status.
When the Close button displays, you can close the dialog box.
Default Zoning is not supported in Open Fabric Mode.
Fabric Zoning
165