Installation Conditions
(2) Frame
The MR head bias of the HDD disk enclosure (DE) is zero. The mounting frame
is connected to SG.
Use M3 screw for the mounting screw and the screw length should
satisfy the specification in Figure 3.3.
The tightening torque must be 0.49N·m(5kgf·cm).
When attaching the HDD to the system frame, do not allow the
system frame to touch parts (cover and base) other than parts to
which the HDD is attached.
(3) Limitation of mounting
Note)
Bottom surface mounting
2
A
Frame of system
cabinet
3.0 or less
Details of A
3-4
IMPORTANT
These dimensions are recommended values; if it is not possible to
satisfy them, contact us.
2.5
DE
Frame of system
cabinet
Screw
3.0 or less
Figure 3.3 Mounting frame structure
Side surface
2.5
mounting
2.5
PCA
Screw
Details of B
2.5
B
C141-E171-03EN