Fujitsu MHM2100AT - Mobile 10 GB Hard Drive Product Manual page 157

Interface
(34) SECURITY SET PASSWORD (F1h)
This command enables a user password or master password to be set.
The host transfers the 512-byte data shown in Table 5.13 to the device. The
device determines the operation of the lock function according to the
specifications of the Identifier bit and Security level bit in the transferred data.
(Table 5.14)
Issuing this command in LOCKED MODE or FROZEN MODE returns the
Aborted Command error.
Table 5.13 Contents of SECURITY SET PASSWORD data
Word
1 to 16
18 to 255
Table 5.14 Relationship between combination of Identifier and Security level, and
operation of the lock function
Identifier
User High
Master High
User Maximum
Master Maximum
5-80
0 Control word
Bit 0 Identifier
0 = Sets a user password.
1 = Sets a master password.
Bits 1 to 7 Reserved
Bit 8 Security level
0 = High
1 = Maximum
Bits 9 to 15 Reserved
Password (32 bytes)
17 Master password version number
Reserved
Level
The specified password is saved as a new user password.
The lock function is enabled after the device is turned off
and then on. LOCKED MODE can be canceled using the
user password or the master password already set.
The specified password is saved as a new master password.
The lock function is not enabled.
The specified password is saved as a new user password.
The lock function is enabled after the device is turned off
and then on. LOCKED MODE can be canceled using the
user password only. The master password already set
cannot cancel LOCKED MODE.
The specified password is saved as a new master password.
The lock function is not enabled.
Contents
Description
C141-E104-03EN