Notice - Philips 40PFL4706 User Manual

User manual
Hide thumbs Also See for 40PFL4706:
Table of Contents

Advertisement

1 Notice

2011 © Koninklijke Philips Electronics N.V. All rights reserved.
Specifi cations are subject to change without notice.
Trademarks are the property of Koninklijke Philips Electronics
N.V. or their respective owners. Philips reserves the right to
change products at any time without being obliged to adjust
earlier supplies accordingly.
The material in this manual is believed adequate for the
intended use of the system. If the product, or its individual
modules or procedures, are used for purposes other than
those specifi ed herein, confi rmation of their validity and
suitability must be obtained. Philips warrants that the material
itself does not infringe any United States patents. No further
warranty is expressed or implied.
Philips cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of
the content in this document. Errors reported to Philips will be
adapted and published on the Philips support website as soon
as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although
it has effective pixels of 99.999% or more, black dots or bright
points of light (red, green or blue) may appear constantly on
the screen. This is a structural property of the display (within
common industry standards) and is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove
covers to the inside of the product. Repairs may only be done
by Philips Service Centers and offi cial repair shops. Failure to
do so shall void any warranty, stated or implied.
Any operation expressly prohibited in this manual, any
adjustments, or assembly procedures not recommended or
authorized in this manual shall void the warranty.
Federal Communications Commission Notice
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
Declaration of Conformity
Trade Name :
PHILIPS
Responsible Party :
P&F USA, Inc.
Model :
40PFL4706
Address :
PO Box 430 Daleville, IN
47334-0430 U.S.A.
Telephone Number : 1-866-309-0841
Modifi cations
The FCC requires the user to be notifi ed that any changes
or modifi cations made to this device that are not expressly
approved by Philips Consumer Electronics may void the user's
authority to operate the equipment.
Cables
Connections to this device must be made with shielded
cables with metallic RFI / EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Canadian notice
Standard Television Receiving Apparatus, Canada BETS-
7 / NTMR-7.
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
FCC Caution: Any changes or modifi cations not
expressly approved by the party responsible for
compliance could void the user's authority to
operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Country Code Statement
For product available in the USA market, only channel 1~11 can
be operated. Selection of other channels is not possible.
To maintain compliance with FCC RF exposure requirements, use
only belt-clips, holsters or similar accessories that do not contain
metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
FCC Radiation Exposure Statement
This equipment is compliance with SAR for general population/
uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had
been tested in accordance with the measurement methods and
procedures specifi ed in OET Bulletin 65 Supplement C. This
equipment should be installed and operated with minimum
distance 2.5cm between the radiator & your body.
Copyright
All other registered and unregistered trademarks are the
property of their respective owners.
ENERGY STAR
of the U.S. Environmental Protection
Agency and the U.S. Department
of Energy helping us all save money
and protect the environment through
energy effi cient products and
practices.
Consumer Notice:
This TV has been set to maximize energy effi ciency while
delivering the best possible picture using the factory installed
home mode settings.
Changing or enabling other features in this TV (e.g. brightened
backlighting)
will possibly increase energy consumption beyond the original
ENERGY STAR
R R qualifi ed limits.
®
SRS TruSurround HD™ creates an
immersive, feature-rich surround
sound experience from two speakers,
complete with rich bass, high
frequency detail and clear dialog.
is a trademark of SRS Labs, Inc. TruSurround HD
technology is incorporated under license from SRS Labs, Inc.
R R is a joint program
®
EN
5

Advertisement

Table of Contents
loading

Table of Contents