Cleaning And Special Maintenance; Filter Assembly; Troubleshooting - Haier HDW9SST Instructions For Use Manual

Cleaning and Special Maintenance

Filter Assembly

For the best performance and results, the filter assembly must be keep clean.
The filter removes food particles from the wash water, allowing the water to be recirculated during the cycle.
For this reason, it is a good idea to remove any food particles trapped in the filter after each wash cycle by
rinsing the semi-circular filter and cup "A" under running water. To remove the filter assembly, pull the
handle in an upward direction. The entire filter assembly (made up of the semicircular filter "A" and the fine
filter "B") should be cleaned at least once a month use a soft brush. To reassemble, insert the entire assem-
bly into the dishwasher, locate it correctly in its seat and pressing downward.
The dishwasher must not be used without the filters. Improper replacement of the filters may reduce the
performance of the appliance.
Cleaning the Spray Arms
Food particles may become encrusted on the spray arms and block the hole (see "Close up view [interior]"
on page 3, letters C-E ). Check the spray arms periodically and clean them when needed.

Troubleshooting

Resolving minor problems yourself
Experience has shown that you can resolve most problems that rise during normal daily usage yourself,
without having to call out a service engineer.Not only does this save costs,but it also means that the appli-
ance is available for use again that much sooner. The following list of common occurrences and their rem-
edies should help you identify the causes of most problems.
Problems...
...when the appliance is switched on
Appliance does not start up
9
A
B