Haier DW12-CBE6 Use And Maintenance Manual page 9

Assembly Instructions for Integrated Dishwasher
Technical Information for Installation
The control panel (except in the completely built-in version) can be
easily aligned with the kitchen drawers, using the spacers supplied
with the appliance (see Fig.1 and Fig.2). The height of the control
panel is 115 mm, while the three spacers each add 7.5 mm in height.
Adjusting the Height of the Control Panel
If the kitchen decor requires that the height of the panel be modified,
it can be increased by adding spacers at the bottom of the control
panel itself (see Fig.1 and Fig.2). Each spacer adds 7.5 mm in height.
Mounting the Wooden Panel onto the Door and
Sliding the Dishwasher into the Cabinet
During the preparatory stages for installing the dishwasher into
the kitchen cabinet, holes must not be drilled in the sides, or door,
in order to avoid compromising the performance and/or operation
of the appliance. Before working on any internal components, the
unit must be disconnected from the power supply .The maximum
dimensions for the wood panel that can be installed on the door
are: Height - 610 mm ( 725 mm for the completely built-in version);
Width - 598 mm; Thickness:20 mm.
The height dimension of 610 mm must be reduced if the height of
the control panel is increased through the use of the spacers. In
addition, the base must be trimmed if it interferes with the open-
ing of the door.
Using the Drilling Template (Fig.3 - totally built-
in and Fig.4 - integrated with control panel )
Align the top edge of the template (identified with the "A" arrow ) with
the top edge of the panel. On both sides of the template (top and
bottom ) are written the various dimensions that correspond to the
different possible widths for the panel. Align the template with the
side of the panel (left or right), making sure that the panel coincides
with the appropriate dimensions. Mark the positions for the holes for
the screws, using the tip of a drill or a pencil. The three holes closest
to the side should be used(B). Repeat this step on the other side of
the panel ,using the corresponding side of the template.
A
mm B
115
122.5
130
A
137.5
145
152.5
582mm
586mm
590mm
594mm
LARGH.=598mm
LARGH.=598mm
594mm
590mm
586mm
582mm
en
Fig.1
Fig.2
B
Fig.3
Fig.4
8