Cleaning The Airflow Slots; Cleaning The Control Panel And Housing; Troubleshooting; Error Codes - Electrolux Ew6Ha19G User Manual

Use a standard neutral soap detergent to
clean the inner surface of the drum and drum
lifters. Dry the cleaned surfaces with a soft
cloth.
CAUTION!
Do not use abrasive materials or steel
wool to clean the drum.
12.8 Cleaning the control panel and
housing
Use a standard neutral soap detergent to
clean the control panel and housing.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapter

13.1 Error Codes

The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the
Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an error
code and the Avvio/Pausa button may flash continuously:
Error code
Appliance motor overloaded.
E50 Too much laundry or entrapped in the drum.
Internal fail. No communication between
electronic elements of the appliance.
E90 or E91
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
22 ENGLISH
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
Do not use furniture cleaning agents or
cleaning agents which can cause
corrosion.

12.9 Cleaning the airflow slots

Use a vacuum cleaner to remove fluff from
the airflow slots.
Possible cause
CAUTION!
Remedy
The programme was not completed. Re‐
move the laundry from the drum, set the
programme and restart the cycle.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance paused the cycle with‐
out any indication then press the cycle start.
If the warning will occur again check the
power cord / socket integrity or main supply.