Upgrading Firmware On An Individual Disk; Step 7. Entering Storage System Passwords - HP 6400/8400 Software Manual

Figure 25 Code Load Disk Drives
.
11. Click Finish.

Upgrading firmware on an individual disk

If it is necessary to upgrade the firmware on an individual disk, the firmware and installation instructions
can be downloaded from the following website:
http://www.hp.com/support/evadiskfirmware
IMPORTANT:
Upgrading disk drive firmware on an individual disk can be performed online or offline, unless the
disk is a member of a disk group that contains Vraid0 virtual disks. If so, the disk must be ungrouped
before the disk drive firmware can be upgraded.

Step 7. Entering storage system passwords

Estimated time to complete: 10–15 minutes
NOTE:
This step is required only if you use password protection on the storage system. Set the storage system
password by selecting Configure Administrator login options in the WOCP (EVA4400) or use the
OCP (EVA6400/8400).
Long passwords (up to 16 characters) are supported. The password must meet the following
requirements:
66 Upgrading the Enterprise Virtual Array
Page 3 window