Cleaning,Care And Maintenance; Cleaning Information - Siemens Er 64021 Lt Instructions For Use Manual

Cleaning, Care and
Maintenance
Please observe the following information
about cleaning, care and maintenance:
1.
For safety reasons, the gas supply
must be cut off via the flow rate
regulator before all operations. If your
appliance has been converted to
natural gas, pleaseturn off the
respective gas tap.
2.
Remove the mains plug from the
socket.
3.
If the appliance is still warm, wait until
it has cooled down.
4.
Do not use high pressure cleaning
equipment or a steam jet.
5. Any acidic substances, such as lemon
juice and oil, which gets onto the
appliance must be carefullyremoved.
6.
When cleaning, never use flammable
substances such as thinner,
petroleum ether, benzene or acid.
7. Do not use abrasive cleaning agents
to clean the control panel. Otherwise
scratches will appear and the labelling
could be rubbed off.
8.
Clean removable burner parts with
a hot soap solution. Do not clean
in the dishwasher!
Do not use scouring or abrasive
cleaners/implements.

Cleaning information:

1.
The control panel, hob and all other
enamel surfaces should be wiped
clean using a damp cloth and
subsequently rubbed dry.
2.
Remove the grill and clean with
washing up liquid, a sponge and
hot water.
3.
Remove burner body and cover.
Clean with sponge, washing up liquid
and hot water. Make sure that the gas
outflow holes on the burner body are
clean and not blocked.
4. Spark plugs must be deaned with a
small, soft brush. The gas burners
will only work if the spark plugs are
clean.
5. Food residue on the burners
be cleaned off with a cloth that has
been dampened with hot water and
washing up liquid. Only a small
amount of water must
must not reach the interior parts of
the appliance. Make sure that the
spark plug hole is not blocked and is
not damaged during cleaning.
6.
Dry all parts after cleaning and make
sure that the burner body and covers
are fitted correctly. If they are fitted
incorrectly, igniting the bumers will
be difficult.
7.
The burner cover is black
enamel-coated. Thes colour may
change over time due to high
temperatures. This will not affect the
operation of the burners.
8. Refit the grill in its original location.
en
must
be used. Water
9