SITE
PREPARATION
Materials
NOT supplied
Note: Site preparation is recommended for this shed.
Placing the shed on a constructed foundation is required.
Without a constructed
foundation,
occur, causing distortion
and damage to the shed.
Manufacturer
is not responsible for replacing parts
damaged or property lost due to incorrect assembly.
Note: Complete the site preparation and foundation
construction
before unpacking parts and beginning
assem bly.
To prepare
your
shed
site,
1) Consult your local authorities for building codes and
covenants
before beginning foundation
shed.
2) Before any digging, check with local utilities to
determine location of buried cables, pipes, etc.
3) Decide which type of foundation
- Concrete
slab, 4" thick
OR
- Wood platform
Use exterior grade wood. The wood platform should
be set on pier blocks or footing. Consult your local
retailer for help to determine the best anchoring
method for your particular installation. The provided
plans are sized for the minimum number of cuts to
lumber and plywood.
4) Prepare the building site:
- The ground should slope away from the foundation
area to provide drainage.
- The
foundation
surface
- A vapor barrier should be provided to prevent
excessive
condensation
- Follow local building codes for a proper vapor
barrier.
5) Anchoring the shed to the foundation:
- Consult
your local retailer for help to determine
the best anchoring
method for your particular
installation.
- To secure the shed to a concrete slab, use masonry
fasteners available at your local hardware retailer.
- To secure the shed to a wood platform, use 1/4" x
3" long lag screws with washers.
AND
PLATFORM
CONSTRUCTION
with 65006 Shed Kit
settling could
follow
the steps
below:
or erecting
you want:
must
be flat
and
level.
in the shed.
Anchoring
floor
panel
• Secure shed to concrete slab using masonry
fasteners.
•
Dimensions
allow
1" on each
side.
Anchoring
floor
panel
ront
• Secure shed to wood platform using 1/4" x 3" lag
screws.
9
to concrete
slab
side
for shed
to fit within
the nearest
to wood
platform
Need help?
Do you have a question about the 65006 and is the answer not in the manual?