Craftsman 65006 Assembly Instructions Manual page 16

Shed Assembly —Walls/Continued
Align tabs on bottom of back panel (H) with slots along
floor (V) & (W). Lower panel into slots and lock in place
by sliding panel toward rear corner. Note: Use a rubber
mallet to "push" back panel (H) into locked position.
Secure back panel (H) with four easy bolts (T), working
from floor to roof. DO NOT use torque wrench. Use easy
bolt easy driver (U) and hand tighten. Easy bolt head will
be flush when fully seated. DO NOT over tighten easy
bolts. Note: You may hear a click when easy bolt has
been tightened completely.
x4
16