Sharp SDW4523MS Installation Manual
Sharp SDW4523MS Installation Manual

Sharp SDW4523MS Installation Manual

Hide thumbs Also See for SDW4523MS:
BEFORE YOU BEGIN READ THESE
INSTRUCTIONS COMPLETELY AND
CAREFULLY.
IMPORTANT – Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions for the
1
consumer's and local inspector's use.
Note to Consumer – Keep these instructions with your Owner's
2
Manual for future reference.
Skill Level – Installation of this dishwasher requires basic
3
mechanical and electrical skills. Proper installation is the
responsibility of the installer. Product failure due to improper
installation is not covered under the SHARP Consumer Limited
Warranty.
Completion Time – 1 to 3 Hours. New installations require more
4
time than replacement installations.
IMPORTANT: Installation must allow for removal of the dishwasher
in case of future service requirements.
If you received a damaged dishwasher, immediately contact your
dealer or builder.
FOR YOUR SAFETY: Read and observe all cautions and warnings
in this instruction manual. Always wear proper safety gear during
installation process, including gloves and safety glasses or goggles.
Dishwasher: SDW4523MS
INSTALLATION MANUAL
SUFFOCATION HAZARD
Before disposing of the old dishwasher, remove the door or lid from
the appliance. Failure to follow this instruction can result in death
or brain damage if a child gets trapped inside the old appliance.
ELECTRICAL SHOCK HAZARD
To reduce the risk of electric shock, fire or injury to per-
sons, the installer must ensure the installed dishwasher
is completely enclosed and reduce the likelihood of
damage to the power cord.
STATE OF CALIFORNIA PROPOSITION 65
WARNINGS:
To view State of California Proposition 65 warnings
WARNING
related to cancer and reproductive harm, see:
.P65w
.
www
arnings
ca
READ CAREFULLY.
SAVE THESE INSTRUCTIONS.
If you have an installation problem, contact your dealer or installer.
You are responsible for providing adequate electrical, exhausting
and other connecting facilities.
1
1
WARNING
.
gov
October 31, 2024
Table of Contents
loading
Need help?

Need help?

Do you have a question about the SDW4523MS and is the answer not in the manual?

Summary of Contents for Sharp SDW4523MS

  • Page 1 Proper installation is the responsibility of the installer. Product failure due to improper STATE OF CALIFORNIA PROPOSITION 65 installation is not covered under the SHARP Consumer Limited WARNINGS: Warranty. To view State of California Proposition 65 warnings Completion Time –...
  • Page 2: Materials And Tools

    MATERIALS AND TOOLS PARTS SUPPLIED MATERIALS FOR NEW INSTALLATIONS ONLY NAME & DESCRIPTIONS QTY. PARTS NAME & DESCRIPTIONS PARTS Top brackets Air Gap for Drain Hose, if required 4 x 14 screws Ø Waste Tee for House Plumbing, if (For top brachets) applicable ST3.5 x 16 (For side mounting holes)
  • Page 3 MATERIALS AND TOOLS FOR NEW INSTALLATIONS ONLY NAME & DESCRIPTIONS PARTS Tubing Cutter Drill and Appropriate Bits Hole Saw Set...
  • Page 4: Location Requirements

    LOCATION REQUIREMENTS IMPORTANT: • Do not run drain lines, water lines or electrical wiring where they • Do not install the dishwasher over carpeted flooring. can interfere with or contact dishwasher motors or legs. • The dishwasher must be fully enclosed on the top, sides and back. •...
  • Page 5: Installation Preparation

    INSTALLATION PREPARATION CABINET DIMENSIONS CLEARANCES • This dishwasher is designed to be enclosed on the top and on When installed in a corner, allow 2" minimum clearance between both sides by a standard residential kitchen cabinet unit. dishwasher and adjacent cabinets, walls or other appliances. Allow •...
  • Page 6: Electrical Requirements

    " maximum diameter hole to allow the electrical cable. instructions. The hole must be free of sharp edges. If the cabinet wall is metal, the hole edge must be covered with a bushing. • Cable direct connections may pass through the same hole as the drain hose and hot water line, if convenient.
  • Page 7: Installation Instructions

    IMPORTANT: If you received a damaged dishwasher, With another person holding the dishwasher to prevent it from tip- immediately contact Sharp Customer Service at 1-800-BE-SHARP ping, open the door slowly. • If the door drops too freely, increase the spring tension.
  • Page 8: Step 3: Adjust Leveling Legs

    INSTALLATION INSTRUCTIONS STEP 3: ADJUST LEVELING LEGS STEP 4A: VERIFY EXISTING UTILITY CONNECTIONS Move the dishwasher close to the installation location and lay it on its back. WATER CONNECTION Measure the height of the opening from the underside of • Check that the water line reaches to the rear-right side of opening countertop to floor (lowest point).
  • Page 9: Step 5: Connect Drain Hose

    INSTALLATION INSTRUCTIONS PREPARE TO CONNECT WATER LINE CONNECT DRAIN LINE Drill a " (1.3 cm) hole in the cabinet side, rear or floor. See FOLLOW ALL LOCAL CODES AND ORDINANCES. Figure G for preferred and optional locations. The drain hose molded end will fit ", "...
  • Page 10: Step 6: Connect To Water Supply

    INSTALLATION INSTRUCTIONS Route the water supply to the rear-right side of the base. METHOD 2 – HIGH DRAIN LOOP WITH WASTE TEE OR To minimize the noise caused by vibration when using the DISPOSER dishwasher, make sure the supply line does not touch the dishwasher base, frame or motor.
  • Page 11: Step 8: Level Dishwasher

    INSTALLATION INSTRUCTIONS STEP 9: SECURE DISHWASHER STEP 8: LEVEL DISHWASHER IMPORTANT: The dishwasher must be level for proper dish rack IMPORTANT: The dishwasher must be secured to adjacent cabinets operation and wash performance. to keep it from tipping when the door is opened. Level the dishwasher so its front panel is aligned with the adjacent Follow the instructions to install mounting brackets in the manner cabinet doors.
  • Page 12: Step 10: Pre-Test Checklist

    INSTALLATION INSTRUCTIONS STEP 10: PRE-TEST CHECKLIST Secondly, insert the provided screws into the holes, and then tighten to secure the dishwasher to the cabinet. Make sure the tub Review this list after installing your dishwasher to avoid charges is not distorted by pressure from the screws. for a service call that is not covered by your warranty.
  • Page 13: Step 11: Dishwasher Wet Test

    INSTALLATION INSTRUCTIONS STEP 11: DISHWASHER WET TEST Measure the depth of the skirting board of your cabinet. • Turn on power supply (or plug power cord into outlet, if equipped). • Turn on the dishwasher (please refer to the Operation Manual for instructions).
  • Page 14 SHARP ELECTRONICS CORPORATION 100 PARAGON DRIVE • MONTVALE, NEW JERSEY 07645 • USA October 31, 2024...

Table of Contents