Reset Printer Defaults Page; Reset Error Log Page (X2 Tech Only); Web Pmt Settings Page - Xerox 850DP - Phaser Color Solid Ink Printer User Manual

Communication with the printer was successful.
The printer link is up.
The attempt to contact the printer has failed.
The printer link is down.
The printer is currently being used by another user.
Please try later.
The remote printer ethernet address is invalid.
The remote printer queue number is invalid.
Your session has been cancelled.

Reset Printer Defaults Page

Navigation: PRINTER DEFAULTS > UTILITIES > Reset Printer Defaults
Ÿ If you entered the printer password in the Session Setup, you can press the Reset
button to reset the printer settings to the factory default settings.

Reset Error Log Page (X2 TECH only)

Navigation: PRINTER DEFAULTS > UTILITIES > Reset Error Log
Ÿ If you entered the printer password in the Session Setup, you can press the Reset
button to reset the printers error log.
NOTE: After resetting the error log, all entries will be lost.

Web PMT Settings Page

Navigation: PRINTER DEFAULTS > UTILITIES > Web PMT Settings Page
If you entered the printer password in the Session Setup, then to set the units of measure for
the Web PMT pages:
1. Display all appropriate units in - Click on the appropriate radio button, either
mm/cm (millimeters/centimeters) or in. (inches), to select the display units. This will
display the units as selected on all appropriate WebPMT pages.
2. Main Page refresh timeout - This setting is used to refresh the Main Page. The Main
Page will be refreshed the chosen number of seconds.
3. Press the Update Printer button to update the specified parameter changes in the
printer.
Web Print Manager Tool User Guide
If the effort to contact the remote printer
was successful.
Remote printer time out.
Attempting to change the IP when another
WebPMT session is active.
Submitting an invalid IP#.
Submitting an invalid queue number.
Cancelling the remote session.
Page 25