Yamaha 530K Assembly Manual

DTX560K/DTX530K
The DTX560K and DTX530K feature the same Drum units as those of the DTX700K, with the following exceptions:
- Unlike the DTX700K, both the DTX560K and DTX530K have the Drum Trigger Module DTX500.
- Unlike the DTX700K, the DTX530K has the TP65, instead of the XP70.
Accordingly, you should refer to the DTX700K Assembly Manual for details on how to assemble the pads to the rack.
The following description covers assembly of the DTX500 Drum Trigger Module only.
Mounting the drum trigger module
1. Attach the module stand (provided) to the
underside of the drum trigger module using the
module stand fastening screws.
Module stand
fastening screws
Front of
Module
Connect the pads to the drum trigger module
Insert the 9-channel snake cable's straight plugs into the drum trigger module's trigger input jacks ([ q SNARE] to
[ o KICK/ !0 ] and [HI-HAT CONTROL]).
If you are using the standard setup, the stickers on each of the snake cable's plugs will indicate the name of the
NOTE
corresponding pad.
Drum trigger module's rear panel
9-channel snake cable
Straight plugs
Module stand
Drum trigger module
(back side)
1 2
5
L-shaped plugs
HH CON HI-HAT CRASH KICK SNARE TOM1
Assembly Manual
2. Place the module stand inside the holder clamp
and tighten the clamp bolt to secure in position.
Drum trigger
module
+
module stand
Clamp bolt
3 4
6 7 8
Straight plug names DTX500 jack names
(as shown on stickers)
1: q SNARE
SNARE
2: w TOM1/ !0
TOM1
3: e TOM2/ !1
TOM2
4: r TOM3/ !2
TOM3
RIDE 5: t RIDE
6: y CRASH
CRASH
7: u HI-HAT
HI-HAT
8: i KICK/ o
KICK
9: HIHAT CONTROL
HH CON
TOM2 TOM3
Digital Musical Instruments Division
©2011 Yamaha Corporation
WZ78140 106YJ-A0
Insert
Holder Clamp
9
RIDE
EN