Programming Frequently Used Operations; Using A Program - Sharp AR-M280 Operation Manual

PROGRAMMING FREQUENTLY USED OPERATIONS

This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. When you want to send a document to that destination, you can simply call up the program and the steps will
be performed automatically. This function is convenient when you frequently send documents, such as a daily report,
to the same destination. Up to eight programs can be stored.
NOTES
• A program differs from a timer transmission (page 3-4) in that it is not cleared from memory after transmission takes place. A
program thus allows you to repeatedly perform the same type of transmission. Note, however, that programs do not allow you
to establish a timer setting for transmission.
• With the exception of polling, reception operations cannot be stored in a program.
Programs can be stored using the custom settings, and a name up to 18 characters long can be assigned.
For information on storing, editing, and deleting programs, refer to page 6-8.
The following settings can be stored in a program:
• Destination fax number
Auto-dial keys (one-touch or group keys) are used to store the destination fax number. A full number cannot be
entered using the numeric keys. When storing a broadcast transmission or serial polling operation in a program, up to
300 destination fax numbers can be stored.

USING A PROGRAM

1
In fax mode, load the document (page 1-7).
Do not load a document if you are performing a polling
operation.
If you are going to use Dual Page Scan (previous page),
place the document on the document glass.
2
Touch the SPECIAL MODES key and then the
PROGRAM key.
SPECIAL MODES
STANDARD
RESOLUTION
EXPOSURE PROGRAM
3
Touch the program key you wish to execute.
Make sure the key is highlighted and then touch
the OK key.
OK
OG.
GRAM1
• Polling • Dual Page Scan
The program selection
screen appears.
The program key you touched
is selected and you return to
the screen of step 2.
The PROGRAM key is
highlighted.
• Resolution and exposure
4
Touch the OK key.
AKER REDIAL
OK
5
If needed, set the original size and other
settings, and then press the Start key.
Transmission takes place according to the program.
NOTE
Select settings that cannot be stored in a program in step
5. These include original size, two-sided scanning,
verification stamp function (if the optional verification stamp
unit is installed), and a timer setting.
You will return to the initial
screen.
3-11
3