Installing The Firmware And Applications; Verifying And Updating The Firmware - Lexmark 6500e Installation And Configuration Manual

Accessing the Embedded Web Server
Most configuration tasks will be performed through the printer Embedded Web Server, so make sure you are able
to connect:
1
Type the printer IP address or hostname in the address field of your Web browser. If the IP address is not readily
apparent, you can print a network setup page to find it.
2
After you have connected to the Embedded Web Server, use the navigation menu on the left to access
configuration and report menus.
Note: You can find additional information about many application settings using the mouseover help found in the
Embedded Web Server. To access this information, position your cursor over the question mark symbol next to a
setting.
Printing a network setup page
1
From the printer home screen, touch Menus.
2
Touch Reports.
3
Touch Network Setup Page.
The network setup page prints, and the printer returns to the home screen.

Installing the firmware and applications

Verifying and updating the firmware

Enabling PKI support for your printer involves three main components:
•
The printer firmware
•
The authentication token
•
The Lexmark PKI applications
All three must be installed and configured before you install a SmartCard reader on your printer.
Verifying the firmware
1
From the Embedded Web Server, click Reports > Device Information.
2
Under Device Information, scroll down until you see Base =. See the table below to verify that your printer has
the minimum required firmware version.
Printer model
C736
T654
T656
W85x
X46x
X65x
Minimum firmware version
LR.SK.P224cLDc
LR.JP.P224cLDc
LR.SJ.019
LR.JB.P108LDc
LR.BS.P224cLDc
LR.MN.P224cLDc
Configuring PKI-enabled devices
6