Download  Print this page

Lighting & Operating Label; For Your Safety Read Before Operating; Operating Instructions; To Turn Off Gas To Appliance - A.O. Smith RESIDENTIAL GAS WATER HEATER Instruction Manual

A.o. smith residential gas water heater sinstruction manual.
Hide thumbs

Advertisement

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING:
explosion may result causing property damage, personal injury or loss of
life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights the
burner. Do NOT try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
Do not use any phone in your building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1.
STOP! Read the safety information above,
on this label.
2. Set the thermostat to the lowest setting by first pressing
the COOLER
and HOTTER
and holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
3. Set the "ON/OFF" switch on the blower control box to
the "OFF" position.
1. Set the thermostat to the lowest setting by first pressing the COOLER
holding for 1 second. Then press the COOLER
2. Set the ON/OFF switch on the blower control box to the "OFF" position.
3. Turn off all electric power to the appliance if service is to be performed.
If you do not follow these instructions exactly, a fire or

OPERATING INSTRUCTIONS

buttons together

TO TURN OFF GAS TO APPLIANCE

button until the WARM indicator light appears.
25
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in the gas control buttons.
Never use tools. If the control buttons will not push in,
don't try to repair them, call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately contact a qualified installer or service
agency to replace a flooded water heater. Do not attempt
to repair the unit! It must be replaced!
4. This appliance is equipped with a device which
automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
5. Wait five (5) minutes to
If you then smell gas,
the safety information above on this label. If you don't
smell gas, go to the next step.
6. Turn on all electrical power to the appliance.
7. Set thermostat to desired setting by first pressing the
COOLER
and HOTTER
and holding for 1 second. Then press the HOTTER
button.
8. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your
technician or gas supplier.
9. WATER TEMPERATURE ADJUSTMENT
is approximately 120°F.
CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING
and HOTTER
clear out any gas.
STOP! Follow "B" in
buttons together
buttons together and

Advertisement

Table of Contents

   Also See for A.O. Smith RESIDENTIAL GAS WATER HEATER

   Related Manuals for A.O. Smith RESIDENTIAL GAS WATER HEATER

Comments to this Manuals

Symbols: 0
Latest comments: