Asus E35M1-I DELUXE User Manual page 23

User manual
Table of Contents

Advertisement

4.
Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~5)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
E35M1-I DELUXE SATA 6.0Gb/s connectors
• These connectors are set to [IDE Mode] by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors.
• When using hot-plug and NCQ, set the OnChip SATA Type item in the BIOS to [AHCI
Mode]. See section 2.5.2 SATA Configuration for details.
5.
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
E35M1-I DELUXE Front panel audio connector
• We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard's high-definition audio capability.
• If you want to connect a high-definition front panel audio module to this connector, set
the Front Panel Type item in the BIOS setup to [HD]. If you want to connect an AC'97
front panel audio module to this connector, set the item to [AC97]. By default, this
connector is set to [HD]. See section 2.5.5 Onboard Devices Configuration for details.
Chapter 1: Product introduction
SATA6G_2
SATA6G_1
SATA6G_4
SATA6G_3
SATA6G_5
PIN 1
PORT1 L
GND
PORT1 R
PRESENCE#
PORT2 R
SENSE1_RETUR
SENSE_SEND
PORT2 L
SENSE2_RETUR
HD-audio-compliant
pin definition
AAFP
PIN 1
MIC2
AGND
MICPWR
NC
Line out_R
NC
NC
Line out_L
NC
Legacy AC'97
compliant definition
1-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents