Installing Your Washer; Installation Flow Chart - Samsung WF361BVBEWR/A1 User Manual

setting up your washer

INSTALLING YOUR WASHER

Before STEP 5 is complete, do not plug the power cord into a wall socket.
CAUTION
Packaging materials can be dangerous to children; keep all packaging material (plastic bags,
polystyrene, etc.) well out of the reach of children.
WARNING

Installation flow chart

Selecting a
location
Please
check again
before
steps.
Yes
STEP 1
Selecting a location
Before you install the washer, make sure the location:
• Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
• Has no dust, oil, detergent etc.
• Is away from direct sunlight.
• Has adequate ventilation.
• Will not have temperatures at or below 32 ˚F or 0 ˚C.
• Is away from heat sources such as oil or gas.
• Has enough space so that the washer doesn't stand on its power cord.
STEP 2
Removing the Shipping Bolts
Before using your washer, you must remove all shipping
bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
16_ setting up your washer
WF361_363_365-02832J-03_EN_20120829.indd Sec5:16 WF361_363_365-02832J-03_EN_20120829.indd Sec5:16
Removing the shipping
bolts (*Drum only)
Powering your washing
Adjusting the
machine
levelling feet
Does
your washer
have excess vibration
No
or noise?
Connecting the water
and the drain
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary
(about 4~5 Towels)
Finish the
installation
2012-08-31 2012-08-31 12:38:17 12:38:17