Error Code Chart - Electrolux EWFLS70JIW Wiring Diagram

Error
code
E11 Fill time too long.
E13 Water leak in tub or air leak in air bell.
E21 Water not pumping out fast enough.
E25 Recirculation Pump Relay Sense
E26 Recirculation Pump Relay
E31 Electronic pressure switch failure.
E32 Pressure sensor calibration problem.
E35 Pressure sensor indicates water overfill.
E38 Air trap clogged.
E41 Control board thinks the door switch is open.
E42 Door lock device failure
E44 Door closed sensing failure.
E45 Line door sensing failure.
E46 Door command sense.
E49 Door incongruence between door line and door sense.
E52 Bad signal from tacho generator.
E53 Low Voltage to Motor Control Board.
E54 Over speed.
E55 Under speed.
E57 High current on inverter.
E58 High current on motor phase.
E59 No tacho signal for 3 seconds.
E5A High temperature on heat sink caused by overloading.
E5C High Voltage experienced by MC.
E5D Communication problem.
E5F MC is continuously resetting.
E67 Heater sensing relay failure.
E68 Current leakage to ground on heater or fuse opened.
E71 Drum water NTC failure. (Tub heater)
E74 Wash temperature does not increase.
E91 Communication error between UI board and main control board.
E92 UI_MB communications error
E93 Console or Main Board control problem.
E94 Main Board control problem.
E97 Console or Main Board control problem.
E98 Console control problem.
E9B Communication problem between microprocessor
and external EEPROM.
E9F Communication protocol
EA1 Power supply frequency out of limits
EA2 Power supply voltage too high
EA3 Power supply voltage too low
EA5 Main Voltage sensing failure
EAE Line safe relay sensing failure
EF1 Clogged drain pump.
EF2 Too much soap.
EF5 Incorrect water temperature.
EF6 Control Reset
EF8 Key Stuck

Error code chart

Fault condition
Refer to test (1).
Refer to test (2).
Refer to test (3).
Refer to Test (17)
Refer to Test (17)
Refer to test (4).
Refer to test (4).
Refer to test (5).
Refer to test (5).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (7).
Refer to test (15).
Refer to test (9).
Refer to test (9).
Refer to test (8).
Refer to test (8).
Refer to test (9).
Refer to test (8).
Refer to test (12).
Refer to test (10).
Refer to test (10).
Refer to test (13).
Refer to test (13).
Refer to test (14).
Refer to test (14).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (10).
Refer to test (11).
Refer to test (10)
Refer to test (12).
Refer to test (12).
Refer to test (12).
Refer to test (12).
Refer to test (12).
Unclog the drain pump.
Advise customer to reduce the amount
of soap they are using.
Refer to test (16)
Refer to Test (18)
Check all buttons
3
Check