Frigidaire FAFS4272LR Tech Data Sheet page 2

2. Turn the program knob (1) click clockwise from the start position. The hot water solenoid will activate and hot water should
enter through the detergent compartment.
3. Turn the program knob (2) clicks from the start position. The bleach water solenoid will activate and cold water should enter
through the bleach compartment.
4. Turn the program knob (3) clicks from the start position. The bleach and the wash water solenoids will activate and cold
water should enter through the softener compartment.
5. Turn the program knob (4) clicks from the start position. The prewash solenoid will activate and cold water should enter
through the prewash compartment.
6. Turn the program knob (5) clicks from the start position. The door lock solenoid will deactivate and the loading door can be
opened. When the door is opened, the drum light should turn
7. Turn the program knob (6) clicks from the start position. The door lock will activate and the washer will fill then tumble.
Once tumbling has started, the Boost Heater will turn on.
8. Turn the program knob (7) clicks from the start position. This is a free position on models without a recirculation pump. The
recirculation pump and drum light will activate if so equipped.
9. Turn the program knob (8) clicks from the start position. The drain pump will activate draining out any water in the tub. To
enable high spin, press the Delay Start key.
10. Turn the program knob (9) clicks from the start position. The control will signal the last 5 error codes with E00
error.
11. Turn the program knob (10) clicks from the start position. Latest software version will be shown.
12. If applicable, turn the program knob (11) clicks from the start position. This is a free position.
Exiting Diagnostic Mode
To return the washer to normal operation:
a) Unplug the power cord, wait 5-8 seconds, then reconnect the power cord OR
b) Turn the program knob clockwise back to the Start Position. Press the
until the LEDs stop flashing.
FACTORY RESET
1¼"x2" display models, wake machine, push the spin speed and soil selection keys simultaneously and hold until you hear a
beep. This is no more than 10 seconds.
on, if so equipped.
"cancel" and center
2
being no
button under the display