Provisioning Options - Cisco TELEPRESENCE MOVI 4.1 - ADMINISTRATOR GUIDE V4.1.1.9724 Administrator's Manual

Note: For more on managing provisioning templates, see the Provisioning deployment guide.

Provisioning options

The "Default" column in the table below describes how Movi behaves if no specific provisioning
information is configured.
Note: Some settings are only available in TMS 12.6 or later, after uploading the
MoviProvisioningConfigTemplate.xml file, as described above. See the "Description" column.
Field Default
ClearPath Off
Default Mediatype Host
Candidate
Enable Far End On
Camera Control
Enable ICE Off
Cisco TelePresence Movi Administrator Guide (4.1)
Deploying and upgrading the client
Description
ClearPath is a Cisco TelePresence solution that minimizes
the negative effects of packet loss in a non-optimal network.
Among the mechanisms used are H.264-specific error
recovery techniques, feedback from decoders and forward
error correction (FEC).
Both call participants must support ClearPath for it to take
effect.
This setting is only available in TMS 12.6 or later after
uploading the MoviProvisioningConfigTemplate.xml file.
The address to use before ICE has completed, if ICE fails or
if the remote side does not understand ICE. The available
options are:
Host
n
Rflx
n
Relay
n
Relay is the recommended setting if changing the default.
This is typically needed when Movi is deployed in
environments where most other endpoints do not
understand ICE. See the Enabling ICE section.
This setting is only available in TMS 12.6 or later after
uploading the MoviProvisioningConfigTemplate.xml file.
This setting lets Movi control far end cameras, when allowed
by the far end.
This setting is only available in TMS 12.6 or later after
uploading the MoviProvisioningConfigTemplate.xml file.
Interactive Connectivity Establishment (ICE) dynamically
discovers the best possible path for media to travel between
call participants.
See the Enabling ICE section for more information on what
is required to enable this setting.
This setting is only available in TMS 12.6 or later after
uploading the MoviProvisioningConfigTemplate.xml file.
Page 13 of 29