GE DBVH520GJ Installation Instructions Manual page 12

20. Turn the door over and fasten the outer door to the inner
door using the 6 large tapping screws (#10).
MOVE STRIKE BRACKET
21. Using a putty knife or any other flat tool, remove the 5
plastic screw caps located on the dryer where the door will
be installed and install them on the opposite side.
22. Switch the strike bracket and its cover to the opposite side by
removing the screws; then reinstall both on the opposite side.
Installation Instructions
REINSTALL DOOR ASSEMBLY
23. The door is now ready to be installed on the dryer. To ease
12
this step, the hinge has keyholes that allow a partially
fastened screw to be used as a hook.
Partially fasten a screw to the uppermost screw hole. Hook
the door on the partially fastened screw.
Fasten the hinge by installing the other 4 screws and
tightening the partially fastened screw above.
Partially
Inserted Screw
Tighten All
Screws
14 SERVICING
WARNING - LABEL ALL WIRES PRIOR
TO DISCONNECTING WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION
AFTER SERVICING/INSTALLATION.
For replacement parts and other information, refer to Owner's
Manual for servicing phone numbers.