Advertisement
Problem
Possible Cause
Solution
Won't Drain/
Low voltage or using
Check electrical source or call
Won't Spin/
an extension cord.
electrician. Do not use an extension
Wet Loads
cord.
(cont'd)
Cold rinses.
Cold rinses leave loads wetter than
warm rinses. This is normal.
Continues
Drain hose is less than
Raise the drain hose
to Fill/
39 inches above floor.
(see "INSTALLATION',' S ection D).
Continues
to Drain/
Drain hose fits tightly into
Adjust drain hose for loose fit
Cycle Stuck
standpipe.
(see "INSTALLATION';Section D).
Drain hose taped into
Do not seal off drain hose with tape.
standpipe.
The drain hose needs an air gap.
Washer Makes
Load is unbalanced.
Redistribute load.
Noise
Laundry center is not level.
Level laundry center
(see "INSTALLATION';Section I).
Floor not strong enough
Relocate laundry center
to support laundry center.
(see "INSTALLATION',' S ection A).
Gears engaging after drain
This is normal.
and before spin.
Upper part of agitator clicks
This is normal.
during wash.
Won't Fill/
Water inlet valve
Clean screens.
Won't Rinse/
screens are phJgged.
Won't Agitate/
Wrong
Water is turned off.
Turn on water.
Temperature
Hot and cold hoses are
Reverse hoses
reversed.
(see "INSTALLATION'ISections E & F).
Inlet hose is kinked.
Straighten hoses.
Timer dial is not lined up.
Turn timer knob to the right slightly
and pull to start.
Power cord not plugged in.
Plug in power cord.
55
Advertisement
