Installing The Sdram Module - Ricoh Aficio SP 5210DN Hardware Manual

11. Fasten the controller board to the printer with the two screws.
First install the optional hard disk, and then install the SD card provided with the hard disk. For details
about the installation procedure, see p.66 "Installing the SD Memory Card Options".
• After finishing installation, you can check whether the hard disk is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Hard Disk"
will appear for "Device Connection" on the configuration page.
• If the Hard disk is not properly installed, repeat this procedure. If you cannot install it properly even
after reinstallation, contact your sales or service representative.
• For details on printing the configuration page, see p.44 "Test Printing".

Installing the SDRAM Module

• Before touching the SDRAM module, ground yourself by touching something metal to discharge any
static electricity. Static electricity can damage the SDRAM module.
• Do not subject the SDRAM module to physical shocks.
• The printer comes equipped with 256 MB of memory. This can be expanded to a maximum of 768
MB.
1. Turn off the power of the printer, and then unplug the power cable and interface cable.
CEC072
Installing the Memory Expansion Units
3
55