Ricoh Aficio SP 5210DN Hardware Manual page 178

9. Troubleshooting
Set the Print Cartridge correctly.
The print cartridge may not be installed correctly. Turn the printer off and re-install the Print cartridge.
If the message is still displayed after re-installation, contact your sales or service representative.
For details, see p.149 "Replacing the Print Cartridge".
Supply order has failed.
The automatic supply order failed. The message indicates the supplies that the printer tried to order.
This NetBIOS name is already in use.(108/208)
The NetBIOS name specified for the printer is already in use by another device on the network. Consult
your network administrator.
The same IPv4 Address already exists.(102/202)
The IPv4 address specified for the printer is already in use by another device on the network. Consult your
network administrator.
The selected job has already been printed or deleted.
This message might appear if you print or delete a job from Web Image Monitor. Press Exit on the message
screen.
USB has a problem. Please call service.
The printer has detected a USB board failure. Turn the power off, and then on again. If the problem persists,
contact your sales or service representative.
Values set for IPv6/Gateway addresses are invalid.(110/210)
The IPv6 address or gateway address is invalid. Check the network settings.
9
WPA Auth. incomplete.(211)
WPA authentication could not complete. Consult your network administrator.
• Confirm error details by printing the Error Log. For details, see p.44 "Test Printing".
176