Sharp SPC736 Instruction Manual & Warranty

SHARP
SPC736 Diqital Alarm
Instruction
Thank you for your purchase Of this quality clock. The utmost care has gone into the design and
manufacture Ofyour clock Please read these instructions and store them in a safe place for future
reference
CONTROLS
TIME button
2
2. ALARM 1 button
3. + button
3
4 SNOOZE/DIMMER button 4
5. PM indicator
6. ALARM 2 button
7 - button
8. Alarm 1 indicator
5
9. Alarm 2 indicator
CONNECTING TO THE POWER SUPPLY
Begin by plugging in the power cord into a standard household outlet The display will flash indicating
the time is ready to be set
BATTERY BACKUP
The clock time and alarm (if set) can be maintained during a power failure by 2 x AAA battery (not supplied)
Once the power is restored, check the time to make sure it is accurate and re-set if necessary
NOTE: The display will not be lit while the clock is operating under battery use; time will displayonce the power
INSERTING THE BATTERY
1 Open the battery compartment at the back Of the unit by pressing on the catch and removing the cover
2. Insert 2 x AAA battery (preferably alkaline batteries) into the battery compartment, fol owing the polarity
as shown on the diagram inside the compartment
3 Replace the battery compartment cover
SETTING THE CLOCK
- Press and hold the TIME button and the hour digit will flash
- Press the + / - button to set the correct hour. The PM indicator will light when the hour is advanced into
the PM time
- Press TIME button again and the minute digit will flash
- Press the + / - button to set the correct minute and press TIME button to confirm
SETTING THE ALARM
- Press and hold the ALARM 1 / 2 button and the hour digit will flash
- Press the + I - button to set the correct hour. The PM indicator will light when the hour is advanced into
the PM time.
- Press ALARM 1 / 2 button again and the minute digit will flash
- Press the + / - button to set the correct minute and press ALARM 1 / 2 button to confirm
USING THE ALARM FUNCTION
- Press the ALARM 1 / 2 button to activate
- Press the ALARM 1 / 2 button again to deactivate the alarm and the alarm indicator no longer be visible.
NOTE: When the alarm is turned on the alarm time wil display for 5 seconds.
Clock
Manual & Warranty
SNOOZE / DWER
SHARP
/I-41.11- -/::
the alarm and the alarm indicator will be lit
SNOOZE FUNCTION
- Pressing the SNOOZE button after the alarm sounds will cause the alarm to pause and the alarm
will sound again in 9 minutes. This wil happen each time the SNOOZE button is pressed
DIMMER FUNCTION
- To adjust the display brightness, press the DIMMER button to select between 3 levels: Hi - Med - Lo.
BATTERY PRECAUTIONS
Only batteries of the same or equivalent type are to be used
- Batteries are to be inserted with the correct polarity
6
- The supply terminals are not to be short-ciruited
- Exhausted batteries are to be removed from the product
- Do not dispose of batteries in fire; batteries may explode or leak
Adult assembly required to replace and remove battery
7
CARE OF YOUR CLOCK
Replace the back up battery annually, or store the clock without a battery when not in use
A soft cloth or a paper towel may be used to c ean your clock
- Do not use any corrosive cleanser or chemical solutions on the clock
- Keep your clock dry; if it gets wet, wipe it dry immediately. Keep your clock away from dust and dirt.
Handle your clock carefully; do not drop it
- Do not subject the clock to excessive force, shock, dust, temperature, or humidity Any of these
8
conditions may shorten the life of the clock.
9
- Do not tamper with any of the internal components of this clock. This will invalidate the warranty and
may cause damage
Ifcustomer s ervice is needed, please email c ustserv
or call toll free at 1-800-221—0131
Monday-Friday
restored
M.Z. Berger & Company warrants the original consumer purchaser of this product
that it shall be free of defects in materials
purchase date Of this product.
unauthorized modifications
covered by this warranty If a defect covered by this warranty occurs during the
warranty period, wrap your clock carefully
You must include a Roof Of Purchase,
a check or money order for USD $6.00 to cover the cost of handling. Also include
your return address inside the package M Z Berger will repair or replace the clock
and return it to you. M.Z. Berger will not be liable for any loss or damage,
including incidental or consequential damages of any kind; from any breach of
warranty either expressed or implied relating to the product Since some states do
not al ow the exclusion or limitation of incidental or consequential damages, this
limitation may not apply to you
Printed in China
SHARR registered
clocks@mzb.com
and ask for Customer
9:00AM - 4:00 PM EST
One Year Limited Warranty
and workmanship for one year from the
Defects caused by tampering,
or repairs, immersion in water
and send it to the following
M.Z.Berger & co., lnc
353 Lexington Ave - 14th Fl
New York, NY 10016
either the original receipt or a photocopy
Model
in the U.S. Patent and Trademark
Service.
improper use,
or abuse are not
address:
and
SPC736
Office.